Auto repair questions and answer for the Chevy Monte Carlo. Covering all model years. Read some articles that may be related to your problem.
1998 Chevrolet Monte Carlo.
I replaced wheel cylinders in rear brakes moved star adjuster to fully closed had a hard time getting drums back on and now rear brakes seem to be applied when trying to go forward or back how can i relieve pressure ?
2000 Chevy Monte Carlo.
Changed both window regulators, driver's side switch.
I have changed both window regulators and the driver's side switch. The passenger side window works fine, the driver's side will only go down. I checked the wiring where the switch plugs in and everything seems to be OK. Any suggestions.
2005 Chevy Monte Carlo.
My 2005 Monte Carlo engine light keeps coming on after I've change all wires and plugs,it flutters and cuts off when I stop.what can I do?
Answer: first you need to get a scan of the computer to see what codes are stored. I would assume you have a P0300 misfire code, and that is the reason you replaced the spark plugs and plug wires. Did you also look closely at the ignition coils when you did that job?
2002 Chevrolet Monte Carlo has a popping sound in the steering column when the car is moving up and down or when turning and braking at the same time. Know this was common in this model. How do I fix this problem noise.
Answer: A common cause for this noise is what is called the intermediate steering shaft.
2002 Monte Carlo SS. When I go to turn and apply brakes, the Traction System activates and I can barely stop the car. Have to let off brakes and just take corners and especially parking real slow so I don''t hit anything. ABS light will come on once in a while too. When it does it real bad, Traction system and ABS light comes on and traction system turns itself off. What is it and what price am I looking at to have it fixed?
2004 Monte Carlo SS. Engine 3.8L K model. Checked fuses & good. Replaced A/C heater control unit. Question: My car has dual climate control and the drivers side is not producing any heat while the passenger side does.
Turn signal problem with my 2003 Chev Monte Carlo SS. 3.8 V6. Battery is dead. Checked Fuses.
I have a problem with the signals as they don't work. No turn signal or 4-ways. Part 2 - I am getting the car back on the road after 18 months being parked. I would like to know what I need to do to get it back on the road. Thank you, I look forward to communicating with you.
2005 Chevy Monte Carlo 3.4l V6.
Check engine light. Scanned code P0172 - rich. Replaced first o2 sensor. What else can the problem be if the o2 sensor graph is still dropping and raising then staying low .
2003 Chevy Monte Carlo. I replaced the PCM with a new one. had it programed and did the relearn procedure twice, car still will not start. When I did the relearn no telltale signs of the security showed.I put a PCM in from a different car and I can start the car but no gas gauge and trans shift points all wrong. When I did the relearn on used pcm the ringer went off the entire time, but no ringer with new computer. PLEASE HELP THANKS.
Question:3800 V6 2001 Chevrolet Monte Carlo SS Codes P1811. Changed transmission fluid and filter after noticing it having a burnt smell.
After the above, I noticed car was taking too long to shift from 1st to 2nd gear and when it did you could feel the change harder than ever before. This does not happen every day I drive the car. I haven't been able to pinpoint any specific time this happens, it just randomly happens.
2006 Chevy Monte Carlo 3.5 V6. Coolant leak: coolant only leaks when engine is cold, after it warms up it stops. It looks like it leaks from the side of the engine right around the belt. Coolant shoots up off the belt. I don't know could it be the water pump, head gasket, thermostat or something else. Do you have any clue where the leak is coming from? Do you guys see this problem a lot in Chevy vehicles and how much would it cost to fix it?
